Wikipedia Products
Case Center
News Center
Laser engraving machine use precautions1. When using automatic focal length, it is necessary to pay attention to whether the automatic focal rod is fastened. If the automatic focal rod is loose, it will cause the top of the workbench to the laser.2. When laser engraving machine is working, it is
2022/12/08 11:16
Selection and use of semiconductor laser power supplyFirst, the basic requirements of semiconductor laser power supply1. Constant current output: short-circuit constant current output, load changes or short-circuit automatic adaptation.2. Output current ripple: ripple, noise and rated output
2022/12/07 15:11
Laser engraving machine in the process of the use of skillsBefore starting work, you should carefully check the spelling of the text portion of the engraving project, and if conditions permit, print the contents and confirm with the customer. If you want to avoid the dislocation of the sculpture in
2022/12/07 15:09
How to repair the failure of CO2 laser power supply?CO2 laser is widely used in laser engraving, laser cutting and other fields, mainly composed of luminescence system, motion system, control system. Next, our company will briefly introduce how to judge and troubleshoot the failure of CO2 laser
2022/12/05 13:54
Laser cutting machine equipment common faults and solutions1, boot without any response▶ Power fuse is burnt out: Replace the fuse.▶ Power input is normal: Check power input and make it normal.▶ Main power switch is damaged: Replace the main power switch.2, no laser output or very weak laser▶
2022/12/05 13:47
Why the laser is weak or has no laser outputWhether the focusing mirror is contaminated: Clean the focusing mirror.Whether the focal length of relief engraving machine equipment changes: readjust the focal length.Whether the optical path is offset: Adjust the optical path carefully.Whether the
2022/12/03 16:44
The reason why the laser head of laser engraving machine does not glowIn the daily use of laser engraving machine, it is often encountered that the laser head of the laser engraving machine does not glow. This article briefly introduces how to deal with the laser head of the laser engraving machine
2022/12/03 16:41
Carbon dioxide laser is a gas laser with CO2 gas as the main working substance (CO2: N2: He=1:7:20). The CO2 laser consists of a discharge tube, a resonator and an electrode. With the addition of a DC high voltage pump, the gas in the discharge tube emits light (the output wavelength is 10.6μm).
2022/09/28 11:19
Along with the continuous development of economy in our country, most areas begin to produce electric power equipment, which makes the national grid electric power output insufficient, coupled with the aging of the power output facilities, eventually causes the voltage at the end of the circuit to
2022/09/28 11:01
Laser operators should have the relevant technical knowledge of laser power supply system. If the large-scale laser power supply system has an emergency situation during operation, the laser operators should diagnose and repair the fault as soon as possible to ensure the normal operation of the
2022/07/21 15:26
The control part of pulsed laser power supply mainly consists of signal source, signal processing and delay regulation, pulse power amplification, energy storage voltage control and other circuits. The main circuit structure of the pulsed laser power supply we developed adopts resonant switching
2022/07/21 15:25
Laser power supply technicians are important members of the operation of laser equipment, but in the operation of laser power supply, will also encounter all kinds of difficulties, today we summarized some of the first-line manufacturers of technical personnel to provide common problems to discuss
2022/07/21 15:24
Submitted successfully
We will contact you as soon as possible
Close